The TP-Link extender is a special device that many people use to make their home WiFi reach all around their house. To change its settings, people usually use a default IP address as it is the easiest gateway of the TP-Link setup page. But, some users are encountering trouble accessing the TP-Link extender IP address due to some reasons. If you’re having the same problem, don’t worry! We’re here to help you. In this blog, we’ll cover why this is happening and share some easy ways to fix it. So, let’s start without further ado!
There can be several reasons why the IP address of your TP-Link extender might not be working. Here are some common issues that you must know.
The first reason behind TP-Link IP address not working is making typos in the IP address while typing.
The next possible reason behind the IP address not working is the usage of an outdated internet browser because an outdated browser does not support internet activities.
To access the default IP of the extender you should have a stable internet connection. If you are connected to a poor or weak internet connection, then you will not be able to access the IP address
The firmware in the device plays a crucial role as it helps the device to work effectively. But when firmware runs on its outdated version, it causes issues like the TP-Link extender IP address not working.
WiFi interference into the networking device also causes issues as it weakens the signal strengths.
Thus, these are the reasons that cause the TP-Link extender IP address not working issue. To fix it all you have to do is implement the further mentioned troubleshooting tips that work effectively and quickly.
Before you implement any time-consuming solution to fix the issue we would like you to power cycle your device. By doing this you can remove the technical glitches and also fix the minor bugs. Below we mentioned easy-to-follow instructions to reboot the device perfectly:
Your TP-Link extender has been successfully rebooted. Now, you can try accessing the TP-Link extender IP address to ensure the issue is resolved or not. If not, then follow the next possible solution.
Double-check that you have configured the extender with the correct IP address settings, subnet mask, and gateway. You can do this by taking the assistance of the user manual that came with your device. In the user manual, you will get all the information related to your device. In case you find any issue, then correct it at the same time.
Now you need to ensure that the extender is properly connected to your main router or access point. To do this checks the Ethernet cable. If you found any damaged or broken cable, then fix and replace the cable with a new one.
Usage of the correct IP address is very important to access the TP-Link extender login page. So, we advise you to cross-check the IP address that use the first time. If you see any mistake in the IP, then correct it at the same time and try to access it.
If none of the above-mentioned troubleshooting techniques work for you, then it’s high time to reset TP-Link extender. You can do this by pressing the reset button located on the back side of the device. Hold the reset button for a couple of seconds. After that, your device reboots automatically and you will get your device at factory default settings.
Hence, these are the hacks that you can use to fix the TP-Link extender IP address not working. Once the issue is fixed you will able to access the IP address of your device.
Disclaimer: We at tplinkrepeater.cc provide online support and information for issues with TP Link WiFi devices. However, we are not involved with any particular organization or brand. The use of trademarks, brand names or logos used on the site should be considered only as for reference purpose. We provide run-time assistance to customers who directly approach us.